PSI - Issue 28

Available online at www.sciencedirect.com Available online at www.sciencedirect.com ScienceDirect Structural Integrity Procedia 00 (2019) 000–000

www.elsevier.com/locate/procedia

ScienceDirect

Procedia Structural Integrity 28 (2020) 1249–1257

1st Virtual European Conference on Fracture Structural Health Monitoring of Adhesively Bonded Joints: Proposing a new Method by use of Polymer Optical Fibers

J. Weiland a *, M. Luber b , R. Seewald a , A. Schiebahn a , R. Engelbrecht b , U. Reisgen a a ISF _ Welding and Joining Institute, RWTH Aachen University, Pontstrasse 49, D-52062 Aachen, Germany b POF-AC - Polymer Optical Fiber Application Center, Technische Hochschule Nürnberg Georg Simon Ohm, Wassertorstrasse 10, D-90489 Nürnberg, Germany

© 2020 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (https://creativecommons.org/licenses/by-nc-nd/4.0) Peer-review under responsibility of the European Structural Integrity Society (ESIS) ExCo This paper presents a new method for monitoring the structural integrity of adhesively bonded joints by integrating a Polymer Optical Fiber (POF) into the adhesive layer. The sensor concept is based on a deformation transfer from the adhesive to the POF, which results in a change in the cross-sectional shape of the POF. The cross-sectional shape influences the optical light propagation in the POF, which can be detected by simple optical measuring devices. The paper describes the general principle and first results of investigations on a structural adhesive (3M Scotch-Weld DP 609). The sensor signal is in a good relation to the stress state of the adhesive layer. © 2020 The Authors. Published by ELSEVIER B.V. This is an open access article under the CC BY-NC-ND license (https://creativecommons.org/licenses/by-nc-nd/4.0) Peer-review under responsibility of the European Structural Integrity Society (ESIS) ExCo Keywords: adhesive bonding; structural health monitoring; polymer optical fiber; single lap joint Abstract According to the current state of the art, adhesively bonded joints cannot be tested completely non-destructively. This is the main motivation to permanently monitor adhesively bonded joints in order to record their structural integrity and - as a result - to ensure safe load transmission. By the use of permanent non-destructive Structural Health Monitoring (SHM) methods, structural damages in the adhesive bond can be detected at an early stage.

* Corresponding author. Tel.: +49 241 80 96275; fax: +49 241 80-92170. E-mail address: weiland@isf.rwth-aachen.de

2452-3216 © 2020 The Authors. Published by ELSEVIER B.V. This is an open access article under the CC BY-NC-ND license (https://creativecommons.org/licenses/by-nc-nd/4.0) Peer-review under responsibility of the European Structural Integrity Society (ESIS) ExCo

2452-3216 © 2020 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (https://creativecommons.org/licenses/by-nc-nd/4.0) Peer-review under responsibility of the European Structural Integrity Society (ESIS) ExCo 10.1016/j.prostr.2020.11.106