PSI - Issue 10

N.M. Vaxevanidis et al. / Procedia Structural Integrity 10 (2018) 333–341 N.M. Vaxevanidis et al. / Structural Integrity Procedia 00 (2018) 000 – 000

337

5

Table 2. Cutting conditions and measured values of surface roughness parameters and main cutting force. No.Exp. n (rpm) f (mm/rev) a (mm) Ra ( μ m) Rt ( μ m) Fc (N) 1 800 0.10 1.5 7.34 37.7 200 2 800 0.10 1.0 4.33 25.6 160 3 800 0.10 0.5 6.02 36.5 90 4 800 0.18 1.5 4.62 25.2 130 5 800 0.18 1.0 4.23 21.1 120 6 800 0.18 0.5 5.52 34.5 80 7 800 0.33 1.5 7.14 33.8 165 8 800 0.33 1.0 8.51 42.7 160 9 800 0.33 0.5 8.02 37.5 100 10 1600 0.10 1.5 1.44 13.2 160 11 1600 0.10 1.0 1.78 11.5 130 12 1600 0.10 0.5 2.03 12.4 85 13 1600 0.18 1.5 4.24 22.2 170 14 1600 0.18 1.0 3.94 19.0 150 15 1600 0.18 0.5 4.00 21.7 100 16 1600 0.33 1.5 5.13 30.7 190 17 1600 0.33 1.0 5.26 26.8 150 18 1600 0.33 0.5 5.28 28.5 110

(a)

(b) Fig. 4. Effect of feed rate on the main cutting force, Fc : (a) n=800rpm ; (b) n=1600 rpm .

(a)

(b) Fig. 5. Effect of feed rate on the mean surface roughness, Ra : (a) n=800rpm; (b) n=1600 rpm.