Issue 70

P. Sahadevan et alii, Frattura ed Integrità Strutturale, 70 (2024) 157-176; DOI: 10.3221/IGF-ESIS.70.09

Effect of printing process parameters on tensile strength and wear rate of 17-4PH stainless steel deposited using SLM process

Priya Sahadevan Lincoln University College, Selangor - 47301, Malaysia priya@lincoln.edu.my, http://orcid.org/0009-0001-8220-3076 Chithirai Pon Selvan School of Science and Engineering, Curtin University, Dubai - 345031, United Arab Emirates, pon.selvan@curtindubai.ac.ae, http://orcid.org/0000-0001-9294-3340 Avinash Lakshmikanthan Nitte Meenakshi Institute of Technology, Bengaluru - 560064, Karnataka, India avinash.l@nmit.ac.in, https://orcid.org/0000-0002-6454-2904 Amiya Bhaumik Lincoln University College, Selangor - 47301, Malaysia amiya@lincoln.edu.my, http://orcid.org/0000-0002-9188-2269 Agustin Flores Cuautle Postgraduate Studies and Research Division- Technological Institute of Orizaba, 94320 Orizaba, Ver., Mexico

Mexican National Council for Science and Technology-CONACYT jose.fc@orizaba.tecnm.mx, http://orcid.org/0000-0003-0468-4764

Citation: Sahadevan, P., Pon Selvan, C., Lakshmikanthan, A., Bhaumik, A., Cuautle, A. F., Effect of printing process parameters on tensile strength and wear rate of 17-4PH Stainless Steel deposited using SLM process, Frattura ed Integrità Strutturale, 70 (2024) 157-176.

Received: 23.04.2024 Accepted: 02.07.2024 Published: 15.08.2024 Issue: 10.2024

Copyright: © 2024 This is an open access article under the terms of the CC-BY 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.

K EYWORDS . 17-4PH SS, Tensile strength, Fracture studies, SLM process, Super Ranking Concept.

157