PSI - Issue 42

Available online at www.sciencedirect.com Structural Integrity Procedia 00 (2019) 000–000 Available online at www.sciencedirect.com ScienceDirect

www.elsevier.com/locate/procedia

ScienceDirect

Procedia Structural Integrity 42 (2022) 433–440

© 2022 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (https://creativecommons.org/licenses/by-nc-nd/4.0) Peer-review under responsibility of the scientific committee of the 23 European Conference on Fracture – ECF23 In the case of an initiated single crack, the experimental set-up delivers different potentials depending on the distance of the probes to the crack. The geometrical model can be used not only for the determination of the crack angle like performed by Hartweg and Bär (2019) but also to calculate the crack size. On the measured data a function is fitted that allows the calculation of the crack length independent of the location of the crack initiation site. The experimental results have shown that it is possible to determine a crack with a size of less than 1 % of the specimen cross-sectional area. © 2020 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/) Peer-review under responsibility of 23 European Conference on Fracture - ECF23 Keywords: Fatigue; Crack Initiation; Crack Propagation; Crack Position Determination; DC Potential Drop Method 23 European Conference on Fracture - ECF23 Determination of Cracks using Multiple DC Potential Drop Measurements – Experimental Verification of an Advanced Model Mike Nahbein and Jürgen Bär * Universität der Bundeswehr München, Institute of Materials Science, D-85577 Neubiberg, Germany Abstract The Direct Current Potential Drop Method (DCPDM) is a frequently used technique for crack detection and crack length measurement in fatigue experiments. Recent investigations have shown that with multiple potential drop measurements the location of crack initiation can be determined in single edge notch specimens (Wiehler and Bär, 2020), (Bär and Nahbein, 2022) and in round bars (Hartweg and Bär, 2019). In the present work a more detailed investigation of crack initiation and propagation is undertaken on round bars to advance the geometrical model by Hartweg and Bär (2019). Three potential probes were equipped on notched steel bars – at 0° (U 1 ), at 120° (U 2 ) and at 240° (U 3 ). The three potentials were measured simultaneously during the fatigue tests using amplifiers of the control electronics. Moreover, the introduction of overloads was used to mark the crack front on the fracture surface in defined intervals to compare crack and size calculated from the potential drop measurements with the real crack size and geometry.

* Corresponding author. Tel.: +49 89 6004-2561; fax: +49 89 6004-3055. E-mail address: juergen.baer@unibw.de

2452-3216 © 2020 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/) Peer-review under responsibility of 23 European Conference on Fracture - ECF23

2452-3216 © 2022 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (https://creativecommons.org/licenses/by-nc-nd/4.0) Peer-review under responsibility of the scientific committee of the 23 European Conference on Fracture – ECF23 10.1016/j.prostr.2022.12.055